Equisys technical notes

Technical guidance, explanations and fixes for our products

PRB: Extra prefix added to fax number on retry when using SR140 device



ID: ZTN1949

This Zetafax technical note applies to:

  • Zetafax 2012 and below


When a Brooktrout SR140 device is set up with a dial prefix enabled and the ‘redial immediately’ setting enabled, if a fax fails to send the first time due to a device communication error the prefix is repeated during the retry resulting in an invalid number being dialled.


This is due to an issue with the redial logic in the Brooktrout SR140 driver when redialling immediately.


To resolve this issue, uncheck the ‘Redial Immediately AND’ option in the SR140 device options in Zetafax Configuration. If a fax fails to send due to a device communication error, the fax will not retry immediately, but will be placed into the Zetafax retry queue. This retry will occur after the specified interval in the Zetafax retry settings.


This has been identified by Equisys as a problem with the software versions given above and will be fixed in the next release of Zetafax.

Last updated: 28th May 2013 (NT/MW)

Keywords: SR140 extra prefix retry


Recent news

I was sitting across the boardroom table from one of our MS Dynamics partners recently, and I was (pleasantly) taken aback when he said enthusiastically “we love selling your software because it ...

Expense management is a factor in all businesses where employees travel for their work or are based remotely. The challenge is always to make the processes around it more efficient by reducing ...