Equisys Technical Notes

Technical guidance, explanations and fixes for our products

PRB: License code is not requested when upgrading Zetafax Server and the server is unable to start

Print

ZTN1959

ID: ZTN1959

This Zetafax technical note applies to:

  • Zetafax 2008 and below

Symptom

When upgrading from Zetafax 2008 or earlier to Zetafax 2012, the installation completes, but there is no prompt for an upgrade code when running the Zetafax Configuration, and Zetafax Server cannot start. On clicking Help > About in the Zetafax Configuration, the version number reports a version lower than 16.0.950.

Cause

Some server files are not updated the first time the installer is run, thus causing an inconsistency between dependent files. These files are:

  • ShareSetup.dll
  • ZFSETUP.EXE

The files reside in the < ZFAX> \SERVER folder, where < ZFAX> is the path to the Zetafax Server installation. The correct file versions should be 16.0.950.

Resolution

Running the Zetafax Server installation in repair mode twice will update the affected server files and produce a fully updated Zetafax Server system.

Status

This has been identified by Equisys as a problem with the software versions given above.

Last updated: 6th June 2013 (NT/MW)

Keywords: Zetafax Server upgrade failure 2008 to 2012

EquisysLogo

Recent news

This article describes the new features and other improvements in the August 2019 release of the Zetadocs Expenses service. Zetadocs Expenses ...

This article describes the new features and other improvements in the latest release of Zetafax. This improves support for using Fax over IP (FoIP) with SIP trunks and public SIP fax services, ...